BRIDGE AND HIGHWAY STRUCTURE REHABILITATION AND REPAIR

Writter:- MOHIUDDIN A. KHAN

Size:- 12.2 mb

DOWNLOAD HERE

HOW TO CALCULATE DEPTH OF SHALLOW FOUNDATION

Deciding the right depth of foundation for a building structure is an important step in the process of building design. Information given in this post will help you decide the proper depth of foundation for a building.

After reading this post you will be able to answer the following questions.

What is a foundation?
What are the factors affecting depth of foundation?
How to calculate depth of foundation?

I- WHAT IS FOUNDATION

Foundation is that part of the structure which receives load of the superstructure and then transmits that load to soil underneath in such a manner so that the soil never fails in shear or never goes through excessive settlement of differential settlement.

II- FACTORS AFFECTING DEPTH OF FOUNDATION:

Before calculating depth of shallow foundation, the following factors have to be considered well in advance.

1. Foundation should be placed at such a depth so that it is safe against damages due to swelling, shrinkage or freezing of sub soil.

2. Bearing capacity of soil beneath the foundation must be adequate to support the load coming from foundation.

3. If foundation has to be placed on cohesive soil then the settlement due to consolidation should not be excessive.

4. Never place foundation on loose or disturbed soils which have a tendency to erode by wind or flood.
5. If possible then foundation should be placed above ground water table as this can avoid cost of pumping, and can prevent instability of soil due to seepage of water into the bottom of an excavation.
6. Make an investigation on foundation soil to know its physical and chemical properties, because presence of sulphate can damage foundation.

III- CALCULATION OF DEPTH OF FOUNDATION

The minimum depth of shallow foundation for a soil can be calculated using the following formula as suggested by Rankine. This is called Rankine’s Formula.

Dmin = (q/g) * [(1 – sinØ) / (1 + sinØ)]2

Where,

Dmin = Minimum depth of foundation in m

g = Density of unit weight of soil in kN/m3

Ø = Angle of repose in Degrees

q = Intensity of load or Safe bearing capacity of soil in kN/m2
Example Calculation

IV- EXAMPLE:

Calculate the minimum depth required for a foundation to transmit a pressure 55 kN/m2 in a cohesionless soil having density 16 kN/m3 and angle of repose 200?

GIVEN DATA:

Intensity of pressure (q) = 55 kN/m2

Density of soil (g) = 16 kN/m3

Angle of repose (Ø) = 200

CALCULATION:

Minimum depth of foundation, according to Rankine,

Dmin = (q/g) * [(1 – sinØ) / (1 + sinØ)]2

Dmin = (55/16) * [(1 – sin200) / (1 + sin200)]2

Dmin = 0.82 m

V- HELPFUL POINTS

For preliminary calculation of depth of foundation, the values of density and angle of repose, as given in the following table can be used.
Soil Type Angle of Repose (in Degree) Unit weight (in kN/m3)
Dry sand 25 – 35 16.0
Moist sand 30 – 35 18.4
Wet sand 15 – 25 19.2
Dry & compacted sand 35 19.2
Clean gravel 30 – 40 17.9
Mixture of gravel & sand 25 – 40 19.2
Rubble stone 45 19.2
Dry clay 30 17.6
Wet clay 15 19.2
Ash 40 6.4

NOTE:

1) The values given the table above are approximate value.
2) To know the density of soil on site you have to test it onsite. There are two common methods which are widely used for determination of density of soil on site. Click the following two links to read the test procedure.